Hyundai Santa Fe: To remove the cargo security screen - Cargo security screen - Interior features - Features of your vehicleHyundai Santa Fe: To remove the cargo security screen

1. Push in the guide pin.

1. Push in the guide pin.
2. While pushing the lever, pull out the cargo security screen.
3. Open the luggage tray and keep the cargo security screen in the tray.

To use the cargo security screen
1. Pull the cargo security screen towards the rear of the vehicle by the handle (1). 2. Insert the guide pin into the guide (2). ✽ NOTICE Pull out the cargo security screen with the handle in the ...

To remove the cargo security screen from the luggage tray
1. Pull up the screen board. 2. Push in the guide pin. 3. While pushing the guide pin, pull out the cargo security screen. WARNING Do not place objects on the cargo security screen. Such objects may be ...

See also:

SS-B Solenoid Valve(ON/OFF). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

General Safety Information and Caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally ...

Output Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...