Hyundai Santa Fe: Drive Plate. Repair procedures - Cylinder Block - Engine Mechanical SystemHyundai Santa Fe: Drive Plate. Repair procedures

Removal and Installation

1.
Remove the automatic transaxle .
2.
Remove the drive plate (A) and the adapter plate (B).
Tightening torque :
117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft)

•
Always use new drive plate (or flywheel) bolts.
•
Apply sealant to the screw part (10mm from the end of the bolt) when reusing the drive plate bolts.
Sealant: Three bond 2403, Loctite 200 or 204
•
Install and uniformly tighten the 7 bolts, in several passes.
3.
Install in the reverse order of removal.

Components and Components Location
Components 1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Piston pin 7. Connecting rod lower bearing 8. Connecting rod bearing cap 9. Ladder frame 10. Oil filter ...

Rear Oil Seal. Repair procedures
Removal 1. Remove the automatic transaxle. 2. Remove the drive plate. 3. Rmove the rear oil sela(A). Installation 1. Install rear oil seal. (1) Apply engine oil to a new oil seal lip. (2) Using SST(09231-H1100, ...

See also:

Description and Operation
Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system ...

Hood Latch. Repair procedures
Replacement [Hood upper latch assembly] 1. After loosening the mounting bolts, then remove the hood upper latch assembly (A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 2. Install ...

Closing the tailgate
To close the tailgate, lower and push down the tailgate firmly. Make sure that the tailgate is securely latched. WARNING - Exhaust fumes If you drive with the tailgate open, you will draw dangerous exhaust ...