Hyundai Santa Fe: Windshield Deicer Switch. Repair
procedures
Inspection
| 1. |
The windshield deicer switch inputs can be checked
using the GDS.
|
| 2. |
To check the input value of windshield deicer switch,
select option "Body Control Module".
|
| 3. |
Select option "Current Data".
|
| 4. |
To perform functional test on SJB outputs, select
"Actuation Test".
|
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the audio unit or the AVN head unit.
|
| 3. |
Remove the heater and A/C controll unit.
|
Installation
| 1. |
Install the heater and A/C control unit.
|
| 2. |
Install the audio unit or the AVN head unit.
|
| 3. |
Connect the negative (-) battery terminal.
|
Repair procedures
Inspection 1. Remove the cowl top cover. 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition ...
See also:
ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer ...
Smart key immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce the risk of unauthorized vehicle use. Your immobilizer system is comprised of a small transponder in the smart key and electronic ...
Door Scuff Trim. Components and Components Location
Component Location 1. Front door scuff trim 2. Rear door scuff trim ...
