Hyundai Santa Fe: 26 Brake Control Solenoid Valve(26/B_VFS). Description and Operation - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe: 26 Brake Control Solenoid Valve(26/B_VFS). Description and Operation

Hyundai Santa Fe DM 2013-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS). Description and Operation

Description

26Brake control solenoid valve(26/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26Brake.


Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81~500.14 (0.1~5.1, 1.42~72.54) Current value(mA) 50~850 Internal resistance(Ω) ...

See also:

Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engine ...

Passive Occupant Detection System (PODS-F). Description and Operation
Description In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passive occupant detection system (PODS-F). If the seat is occupied, PODS-F detects passenger presences status ...

Balance Shaft & Oil Pump. Repair procedures
Removal 1. Remove the timing chain. 2. Install a stopper pin (A) after compressing the balance shaft chain tensioner. 3. Remove the balance shaft chain hydraulic tensioner (B). 4. Remove the balance shaft ...