Hyundai Santa Fe: 4WD ECU. Repair procedures - 4WD Control System - 4 Wheel Drive (4WD) SystemHyundai Santa Fe: 4WD ECU. Repair procedures

Replacement

1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool.
2.
Disconnect the battery negative cable from the battery
3.
Disconnect the 4WD ECU connector (A).
4.
Loosen the nust (A) and then remove the 4WD ECU.
Tightening torque:
9.8 ~11.8N.m (1.0~1.2kgf.m, 7.2~8.7lb-ft)


Installation

1.
Install in the reverse order of removal.
2.
Prior to installing a new ECU, upload the original ECU’s clutch learing to the replacement ECU using the GDS tool.

4WD ECU. Schematic Diagrams
Circuit Diagram 4WD ECU Connector Pin Function 1 CAN communication line (Low) 2 CAN communication line (High) 3 - 4 Pressure sensor signal(+) 5 - 6 Lock mode switch 7 Oil pressure motor B 8 Oil pressure ...

Coupling Assembly
...

See also:

Rolling code programming
Rolling code devices which are "code-protected" and manufactured after 1996 may be determined by the following: Reference the device owner's manual for verification. The handheld transmitter ...

Components and Components Location
Components Location 1. Fuel tank 2. Fuel pump 3. Fuel filter 4. Fuel pressure regulator 5. Canister 6. Fuel tank air filter 7. Fuel tank band 8. Fuel tank pressure sensor (FTPS) 9. Canister close valve ...

Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold tire pressures recommended for your vehicle, the number of people that can be in your vehicle and vehicle capacity weight. ...