Hyundai Santa Fe: 4WD Control System
Side Sill Molding. Repair procedures Valve Body. Repair procedures Certification label
Replacement [Right side] 1. Remove the driveshaft assembly. (RH side) 2. Remove the dust cover (A). 3. Remove the oil seal (A, B). 4. Install the oil seal with special service tools. • Apply lithium ...
Oil Seal. Repair procedures
Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the ...
Repair proceduresSee also:
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Removal 1. Remove the air duct. 2. Remove the battery and the battery tray. 3. Remove the under cover(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Drain the coolant. 5. ...
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Vehicle ...
