Hyundai Santa Fe: Alternator. Specifications - Charging System - Engine Electrical SystemHyundai Santa Fe: Alternator. Specifications

Specification

Alternator
Item
Specification
Rated voltage
13.5V, 130A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built-in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C
Internal mode
-3.5 ± 2mV / °C

※ Regulator Setting Voltage (External mode)

Alternator. Description and Operation
Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage of ...

Alternator. Components and Components Location
Components 1. OAD (Overrunning Alternator Decoupler) 2. Front bracket 3. Front bearing 4. Rotor 5. Rear bearing 6. Rear bracket 7. Through bolt 8. Regulator assembly 9. Regulator bolt 10. Rear cover ...

See also:

Front Alignment. Repair procedures
Front wheel alignment When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels ...

ICM (Integrated Circuit Module) Relay Box. Repair procedures
Inspection Rear Blower Motor relay Check for continuity between the terminals. 1. There should be continuity between the No.16 and No.15 terminals when power and ground are connected to the No.13 and No.14 ...

SS-A Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-A) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) Internal resistance(Ω) 10~11 ...