Hyundai Santa Fe: Engine Electrical System
- General Information
- Ignition System
- Description and Operation
- Repair procedures
- Ignition Coil. Description and Operation
- Ignition Coil. Specifications
- Ignition Coil. Schematic Diagrams
- Ignition Coil. Repair procedures
- Spark Plug. Description and Operation
- Spark Plug. Specifications
- Spark Plug. Repair procedures
- Charging System
- Description and Operation
- Repair procedures
- Alternator. Description and Operation
- Alternator. Specifications
- Alternator. Components and Components Location
- Alternator. Schematic Diagrams
- Alternator. Repair procedures
- Battery. Description and Operation
- Battery. Specifications
- Battery. Components and Components Location
- Battery. Repair procedures
- Battery. Troubleshooting
- Battery Sensor. Description and Operation
- Battery Sensor. Repair procedures
- Starting System
- Description and Operation
- Troubleshooting
- Starter. Description and Operation
- Starter. Specifications
- Starter. Components and Components Location
- Starter. Schematic Diagrams
- Starter. Repair procedures
- Starter Relay. Repair procedures
- Cruise Control System
Muffler. Repair procedures
Removal and Installation 1. Remove the front muffler (A). Tightening torque: 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft) 2. Remove the center muffler (A). Tightening torque: 39.2 ~ 58.8 N.m (4.0 ...
See also:
Components and Components Location
Components 1. Rear bumper cover 2. Rear bumper beam assembly 3. Rear bumper beam cover 4. Rear bumper side bracket [LH] 5. Rear bumper side bracket [RH] 6. Rear bumper lower side bracket ...
Headrest (for rear seat)
The rear seat(s) is equipped with headrests in all the seating positions for the occupant's safety and comfort. The headrest not only provides comfort for passengers, but also helps to protect the ...
Intake Air Temperature Sensor (IATS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within the specification. Specification: ...