Hyundai Santa Fe: Antenna Coil. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
|
| 3. |
Disconnect the 6P connector (B) of the coil antenna
and then remove the coil antenna (A) after loosening the screw.
|
Installation
| 1. |
Install the coil antenna and connect the 6P connector.
|
| 2. |
Install the crash pad lower panel.
|
| 3. |
Connect the negative (-) battery terminal.
|
Immobilizer Control Unit. Repair
procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. 3. Remove the knee airbag module. 4. Disconnect the connector of the immobilizer unit and then remove ...
See also:
Rail Pressure Sensor (RPS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Condition Output Voltage (V) Idle Approx. 1.2 1,500 rpm ...
Engine Coolant Temperature Sensor (ECTS). Schematic Diagrams
Circuit Diagram ...
Floor mat anchor(s)
When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING The floor mat must be properly ...
