Hyundai Santa Fe (DM): Rear Parking Assist System - Body Electrical SystemHyundai Santa Fe (DM): Rear Parking Assist System

Antenna Coil. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening ...

Specifications
Specification Item Specification Ultrasonic sensor Voltage rating DC 12 V Detecting range 30 cm ~ 120 cm Operation voltage DC 9 ~ 16 V Operation current MAX 300 mA Operation temperature -30°C ~ +80°C ...

See also:

Jump starting
Jump starting can be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle. If in doubt about how to properly jump start your ...

Fuel Tank Pressure Sensor (FTPS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at ...