Hyundai Santa Fe: Auto Light Sensor. Repair procedures
Inspection
In the state of IGN1 ON, when the multi function switch module
detects auto light switch on, tail lamp relay output and head lamp low relay
output are controlled according to auto light sensor's input.
If IGN1 ON, The BCM monitors the range of this supply and
raises up a failure as soon as the supply’s voltage is out of range. Then this
failure occurs and as long as this is present, the head lamp must be turned
on without taking care about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the
failure occurs during the night.
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the photo & auto light sensor (A) from crash
pad upper side by using screw (-) driver.
|
| 3. |
Remove the auto light connector.
|
Installation
| 1. |
Reconnect the auto light connector.
|
| 2. |
Install the auto light sensor.
|
Auto Light Switch. Repair procedures
Inspection Operate the auto light switch, then check for continuity between terminals of multi-function switch connector. ...
See also:
Removable towing hook
Rear 1. Open the talegate, and remove the towing hook from the tool case. 2. Remove the hole cover pressing the lower part of the cover on the bumper. 3. Install the towing hook by turning it clockwise ...
Checking the coolant level
Removing radiator cap Never attempt to remove the radiator cap while the engine is operating or hot. Doing so might lead to cooling system and engine damage and could result in serious personal injury ...
Main Crash Pad Assembly. Components and Components Location
Component Location 1. Main crash pad assembly ...
