Hyundai Santa Fe: ESC Control Module. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Santa Fe: ESC Control Module. Repair procedures

Removal

1.
Turn the ignition switch OFF.
2.
Remove the brake fluid from the master cylinder reservoir with a syringe.
•
Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. If not, it may cause contamination of brake fluid and deterioration in braking performance.
•
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Pull up the lock of the HECU connector (A) and then disconnect the connector.
4.
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.
Tightening torque:
A : 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
B : 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

5.
Loosen the HECU bracket nuts (A) and then remove HECU and bracket.
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

1.
Never attempt to disassemble the HECU.
2.
Never shock the HECU.
6.
Remove the bolts and then remove the bracket from HECU.
Tightening torque :
10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)

Installation

1.
Installation is the reverse of removal.
2.
Tighten the HECU mounting bolts and nuts to the specified torque.
3.
After installation, bleed the

ESC Control Module. Components and Components Location
Components 1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ESC control module (HECU) 8. Bracket ...

Front Wheel Speed Sensor. Components and Components Location
Components 1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

See also:

Floor Console Assembly. Repair procedures
Replacement [Console rear complete assembly] [M/T] • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the ...

Rear Seat Frame Assembly. Components and Components Location
Component Location [Second row seat assembly] (LH) 1. Rear seat back frame assembly 2. Rear seat cushion frame assembly (RH) 1. Rear seat back frame assembly 2. Rear seat cushion frame assembly [Third ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...