Hyundai Santa Fe: Flex Steer. Repair procedures - Steering wheel - Steering SystemHyundai Santa Fe: Flex Steer. Repair procedures

Inspection

1.
Check the audio remote control switch (A) for resistance between terminals in each switch position.

Switch
 Connector terminal
 Resistance (±5%)
Cancel
 2-7
 180 Ω
Set
 2-7
 330 Ω
Resume
 2-7
 550 Ω
Cruise
 2-7
 880 Ω
S/Limit
 2-7
 1.44 kΩ
Flex steer
 2-7
 180 Ω


Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
3.
Remove the steering wheel.
4.
Disengage the steering wheel remote control switch assembly.
5.
Remove the remote control switch (A) and (B).
6.
Install in the reverse order of removal.

Flex Steer. Schematic Diagrams
Circuit Diagram ...

Electric Power Steering
...

See also:

Repair procedures
Component Replacement After Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs. When the front airbag(s) ...

Water Temperature Control Assembly. Components and Components Location
Components 1. O-ring 2. Water temperature control assembly 3. Water inlet fitting 4. Engine coolant temperature sensor 5. Thermostat 6. Thermostat gasket 7. Oil cooler coolant hose ...

To defog inside windshield
1. Select desired temperature. 2. Select desired fan speed. 3. Press the defrost button (). 4. The outside (fresh) air position will be selected automatically. If the outside (fresh) air position is not ...