Hyundai Santa Fe: Front Bumper Cover. Repair procedures - Front Bumper - Body (Interior and Exterior)Hyundai Santa Fe: Front Bumper Cover. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Loosen the radiator upper cover mounting bolts and clips.
2.
Loosen the front bumper lower mounting clips.
3.
After loosening the front bumper side's mounting screw, then disconnect the side's.
4.
Disconnect the fog lamp connector (A).
5.
Remove the front bumper cover (A).
6.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Front Bumper Cover. Components and Components Location
Component Location 1. Front bumper cover ...

Radiator Grill. Components and Components Location
Component Location 1. Radiator grill ...

See also:

Input Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...

Front Seat Frame Assembly. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Description and Operation
Description Torque converter control solenoid valve (T/CON) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque converter. ...