Hyundai Santa Fe: Front Door Outside Handle. Repair procedures - Front Door - Body (Interior and Exterior)Hyundai Santa Fe: Front Door Outside Handle. Repair procedures

Replacement

1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the front door outside handle cover (A).

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Remove the front door outside handle (A) by sliding it rearward.

4.
Disconnect the front door outside handle connector (A).

5.
Install in the reverse order of removal.
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.

Front Door Outside Handle. Components and Components Location
Component Location 1. Front door outside handle ...

Front Door Latch. Components and Components Location
Component Location 1. Front door latch ...

See also:

ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 5° TPS TPS 1 fault ECM looks at TPS2 TPS 2 fault ECM looks at TPS1 TPS 1,2 fault Throttle valve stuck at 5° APS APS 1 fault ECM looks at ...

Rear Washer Switch. Repair procedures
Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear Washer Switch ...

To remove the cargo security screen from the luggage tray
1. Pull up the screen board. 2. Push in the guide pin. 3. While pushing the guide pin, pull out the cargo security screen. WARNING Do not place objects on the cargo security screen. Such objects may be ...