Hyundai Santa Fe: Front Door Window Glass. Repair procedures - Front Door - Body (Interior and Exterior)Hyundai Santa Fe: Front Door Window Glass. Repair procedures

Replacement

1.
Remove the front door trim.
2.
Remove the front door belt inside weatherstrip (A).
3.
Remove the front door window glass mounting hole plug (B).

•
Be careful not to drop the glass and/or scratch the glass surface.
•
Use the door switch to align the mounting hole/bolt with the hole in the door.
•
If unable to operate the window motor, remove the motor and align the hole by hand.
4.
Carefully adjust the front door window glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Install in the reverse order of removal.
•
Roll the glass up and down to see if it moves freely without binding.
•
Adjust glass position as needed.
•
Make sure the door lock and opens properly.
•
Replace any damaged clips.

Front Door Window Glass. Components and Components Location
Component Location 1. Front door window glass ...

Front Door Module. Components and Components Location
Component Location 1. Front door module ...

See also:

Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. WARNING A wheel that is not the correct size may ...

Glove Box Housing. Components and Components Location
Component Location 1. Glove box housing ...

Engine Mounting. Repair procedures
Removal and Installation Roll road Bracket 1. Remove the roll road bracket(A). Tightening torque Bolt (B) : 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft) Bolt (C) : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 ...