Hyundai Santa Fe: Front fog light
Fog lights are used to provide improved visibility when visibility is poor due to fog, rain or snow, etc.
1. Turn on the park light.
2. Turn the light switch (1) to the front fog light position.
3. To turn off the front fog light, turn the light switch to the front fog light
position again or turn off the park light.
CAUTION
When in operation, the fog lights consume large amounts of vehicle electrical power. Only use the fog lights when visibility is poor or unnecessary battery and generator drain could occur.
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn signal is ...
Wipers and washers
A :Wiper speed control · MIST – Single wipe · OFF – Off · INT – Intermittent wipe · LO – Low wiper speed · HI – High wiper speed B : Intermittent wipe time adjustment C :Wash with brief ...
See also:
Cruise Control Switch. Schematic Diagrams
Circuit Diagram ...
Front Body. Body Repair
Front Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front Body B * These dimensions indicated in this figure are actual-measurement dimensions. ...
Crankshaft Damper Pulley. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the passenger engine room side cover. 3. Remove the passenger front tire. 4. Remove the crankshaft damper pulley(A). Tightening torque : 166.6 ...
