Hyundai Santa Fe: Front Impact Sensor (FIS). Repair procedures - SRSCM - RestraintHyundai Santa Fe: Front Impact Sensor (FIS). Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS). Repair procedures

Removal

•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front impact sensor mounting bolt (A).
3.
Disconnect the front impact sensor connector.

Installation

•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque :
6.8 ~ 9.2 N.m (0.7 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the radiator upper cover and air duct.
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS). Components and Components Location
Components ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at ...

See also:

Side repeater lamp replacement
If the lamp bulb does not operate, have the vehicle checked by an authorized HYUNDAI dealer. ...

All Wheel Drive (AWD) LOCK Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you select AWD Lock ...

Room Lamp. Repair procedures
Inspection 1. Remove the room lamp assembly then check for continuity between terminals. [General] [Panorama Sunroof] Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) ...