Hyundai Santa Fe: Front Seat Back Cover. Repair procedures - Front Seat - Body (Interior and Exterior)Hyundai Santa Fe: Front Seat Back Cover. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
2.
Remove the front seat shield outer cover.
3.
Pull up the front seat headrest (A) while pressing the locking pin (B).
4.
To remove the front seat headrest (A), put the grimlet (B) into the gap to press the locking pin (C).
5.
Remove the front seat lower protector (A).
6.
Loosen the front seat back board mounting screws (A).
7.
To remove the front seat back board (A), slightly broaden the gap of the upper side of the board and then press the locking pins (B) with a (-) driver.
•
Be careful not to damage the lock pin.

8.
To remove the air ventilation seat back duct (A), widen the both sides of the clips (B) as the direction of the arrow and then pull down the air ventilation seat back duct.

9.
Push the protecter (A) by the front seat back frame.
10.
Remove the velcro tape (A).
11.
Remove the front seat lower protector (A).
12.
Disconnect the connectors (A) and front seat wiring harness (B).
[Front seat cushion part]

[Front seat back part]
13.
Loosen the side airbag (SAB) mounting nuts (A).
14.
Remove the side airbag wiring harness (A).
15.
Turn the front seat back cover inside out. Then pull out the headrest guides (A) while pinching the upper part of the guides, and remove them.
16.
Remove the front seat back cover (A) from the front seat back frame.
17.
After removing the hog-ring clips (A) on the front of seat back and remove the front seat back cover (B).
18.
Install in the reverse order of removal.
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool [C (09880-4F000)].


Front Seat Back Cover. Components and Components Location
Component Location 1. Front seat back cover ...

Front Seat Cushion Cover. Components and Components Location
Component Location 1. Front seat cushion cover ...

See also:

Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel bearing Replace Defective front suspension and ...

Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. To improve the effectiveness of heating and cooling : - Heating: - Cooling: 3. Set the temperature control to the desired position. 4. Set ...

Schematic Diagrams
System Block Diagram Component Parts And Function Outline Component part Function Vehicle-speed sensor Converts vehicle speed to pulse. ECM Receives signals from sensor and control switches. Cruise control ...