Hyundai Santa Fe: Fuel Tank Air Filter. Repair procedures
Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation tube quick-connector (B) from the fuel
tank air filter and canister close valve.
|
| 5. |
Disconnect the vapor tube quick-connector (A).
|
| 6. |
Remove the canister assembly bracket (D) after removing the mounting
bolts (B) and nut (C).
|
| 7. |
Remove the canister braket (B) installation bolt (A).
|
| 8. |
Remove the fuel tank air filter & canister close valve assembly
(A) after rotating it in the direction of the arrow in the figure.
|
| 9. |
Release the lever (A), and then separate the canister close valve
(B) from the fuel tank air filter (C) after rotating it in the direction
of the arrow in the figure.
|
Installation
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
In this case, use it after inspecting.
|
| 1. |
Install in the reverse order of removal.
|
Fuel Filler Cap. Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap and the ...
See also:
Input Speed Sensor. Schematic Diagrams
Circuit Diagram ...
Tilt steering
A tilt steering wheel allows you to adjust the steering wheel before you drive. You can also raise it to give your legs more room when you exit and enter the vehicle (if equipped). The steering wheel should ...
Rear Bumper Cover. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
