Hyundai Santa Fe: Intake Air Temperature Sensor (IATS). Description and Operation
Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute
Pressure Sensor and detects the intake air temperature.
To calculate precise air quantity, correction of the air temperature is
needed because air density varies according to the temperature. So the ECM uses
not only MAPS signal but also IATS signal. This sensor has a Negative Temperature
Coefficient (NTC) Thermister and it's resistance changes in reverse proportion
to the temperature.
Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition ...
Intake Air Temperature Sensor (IATS). Specifications
Specification Temperature Resistance (kΩ) °C °F -40 -40 40.93 ~ 48.35 -20 -4 13.89 ~ 16.03 0 32 5.38 ~ 6.09 10 50 3.48 ~ 3.90 20 68 2.31 ~ 2.57 40 104 1.08 ~ 1.21 60 140 0.54 ~ 0.62 80 176 0.29 ...
See also:
Battery Sensor. Repair procedures
Removal 1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector (A). 3. Remove the battery negative (-) cable after removing the bolts (B). Installation 1. Install in the ...
Camshaft Position Sensor (CMPS). Troubleshooting
Wave Form ...
Power Seat Control Switch. Repair
procedures
Inspection Power Seat Control Switch 1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...
