Hyundai Santa Fe: Movable Glass. Repair procedures - Body Side Molding - Body (Interior and Exterior)Hyundai Santa Fe: Movable Glass. Repair procedures

Replacement

1.
Tilt the rear part of the movable glass (A) using the panorama sunroof switch.
2.
Remove both sides of the decoration cover (A).
3.
Loosen the mounting screws (A) on both sides.
•
Be careful not to damage the screws.

4.
Carefully lift up the movable glass (A) and then remove it.
5.
Install in the reverse order of removal.
•
After replacing the movable glass adjust the alignment if needed.

Repair procedures
Adjustment Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. Alignment adjustment Standard value [mm(in.)] ...

Panorama sunroof
...

See also:

Components and Components Location
Components Location 1. Purge Control Solenoid Valve (PCSV) 2. Vapor line 3. Fuel tank air filter 4. Canister Close Valve (CCV) 5. Canister 6. Fuel Tank Pressure Sensor (FTPS) ...

Panoramic sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, closed, or tilted when the ...

Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Inspect the PCV vlave operation. (1) Run the engine at idle. ...