Hyundai Santa Fe: Repair procedures - Body Side Molding - Body (Interior and Exterior)Hyundai Santa Fe: Repair procedures

Adjustment

Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it.

Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)

2.
Adjust the height of the glass by slighty loosening the screws (A).
•
Be careful not to damage the screw.

Emergency operation
1.
Use the panorama sunroof emergency operation only when you have to open or close the sunroof when there is a problem with the engine.
2.
Use a hexagon wrench to open or close the panorama sunroof after removing the Do not apply too much force when opening or closing the
[Movable Glass Motor ]

[Roller Blind Motor]

3.
If needed reset the panorama sunroof according to the reset method.

Components and Components Location
Components 1. Roof side moulding [LH] 2. Roof side moulding [RH] 3. Movable Glass 4. Slide 5. Cover base 6. Wind deflector 7. Center cover 8. Panorama sunroof frame assembly 9. Mechanism rail assembly ...

Movable Glass. Repair procedures
Replacement 1. Tilt the rear part of the movable glass (A) using the panorama sunroof switch. 2. Remove both sides of the decoration cover (A). 3. Loosen the mounting screws (A) on both sides. • Be careful ...

See also:

If you have a flat tire while driving
If a tire goes flat while you are driving: 1. Take your foot off the accelerator pedal and let the car slow down while driving straight ahead. Do not apply the brakes immediately or attempt to pull off ...

Automatic climate control system
Type A Type B 1. A/C display 2. AUTO (automatic control) button 3. Blower OFF button 4. Air conditioning button 5. Driver's temperature control button 6. Front fan speed control knob 7. Air intake ...

Air conditioning
HYUNDAI Air Conditioning Systems are filled with environmentally friendly R-134a refrigerant. 1. Start the engine. Push the air conditioning button. 2. Set the mode to the position. 3. Set the air intake ...