Hyundai Santa Fe: Body Side Molding
Crach Pad Center Panel. Repair procedures Fuel Pressure Control Valve. Repair procedures Audio system
Replacement 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, then remove the rear door side weatherstrip (A). ...
Rear Door Side Weatherstrip. Repair procedures
Replacement [General Type] • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent ...
Roof Rack. Repair proceduresSee also:
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fuel pressure regulator ...
✽ NOTICE If you install an aftermarket HID headlamp, your vehicle's audio and electronic device may malfunction. ...
