Hyundai Santa Fe: Oil Cooler. Repair procedures - Lubrication System - Engine Mechanical SystemHyundai Santa Fe: Oil Cooler. Repair procedures

Removal

1.
Loosen the drain plug, and drain the coolant. Remove the radiator cap to help drain the coolant faster.
2.
Disconnect the oil cooler coolant hoses (A).

3.
Remove the oil filter (A).

4.
Loosen the mounting bolt (A) and remove the oil cooler assembly (B).


Installation

1.
Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B).

Tightening torque:
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

Fix position of oil cooler stopper(A) where oil cooler resists on ladder frame stopper (B).

2.
Apply a light coat of engine oil to the oil filter packing surface (A), and then install the oil filter.

Tightening torque:
11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)

3.
Connect the oil cooler coolant hoses (B).

4.
Fill the radiator with coolant and check for leaks.

Engine Oil. Repair procedures - Revised
Oil and filter replacement • Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used ...

Oil Pan. Repair procedures
Removal 1. Remove the drive belt.   2. Remove the A/C compressor. 3. Remove the A/C compressor bracket (A). 4. Drain the engine oil. 5. Remove the oil pan (A). Insert the blade of SST (09215-3C000) ...

See also:

Programming HomeLink®
✽ NOTICE When programming a garage door opener, it is advised to park the vehicle outside of the garage. It is recommended that a new battery be placed in the hand-held transmitter of the device ...

Outside Rear View Components and Components Location
Component Location 1. Outside rear view mirror ...

Heated Oxygen Sensor (HO2S). Schematic Diagrams
Circuit Diagram ...