Hyundai Santa Fe: SS-A Solenoid Valve(ON/OFF). Description and Operation - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe: SS-A Solenoid Valve(ON/OFF). Description and Operation

Description

SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears.
SS-A Solenoid valve(ON/OFF) is installed at valve body.


Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

SS-A Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-A) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) Internal resistance(Ω) 10~11 ...

See also:

Schematic Diagrams
Schematic Diagrams MDPS Circuit Diagram Harness Connector Connector Pin no Pin name Battery 1 Battery + 2 Battery - Vehicle signal 1 Igntion 2 - 3 - 4 - 5 - 6 - 7 CAN_High 8 CAN_Low ...

Rheostat. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad side cover. 3. Remove the lower crash pad switch assembly (A) after loosening the screws (3EA). 4. Remove the rheostat ...

Fuel Filler Door Open Switch. Repair procedures
Inspection 1. Remove the front door trim. 2. Disconnect the switch connector (A) from wiring. 3. Check the switch for continuity between the No. 1 and No. 2 terminals. If the continuity is not as specified, ...