Hyundai Santa Fe: Parking Brake Pedal Assembly. Repair procedures - Parking Brake System - Brake SystemHyundai Santa Fe: Parking Brake Pedal Assembly. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Brake System / Parking Brake System / Parking Brake Pedal Assembly. Repair procedures

Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
3.
Remove the junction box.
4.
Disconnect the parking brake switch connector.
5.
Remove the parking brake cable mounting nuts (A).
6.
Remove the parking brake pedal mounting bolts (A) and nut (B).
7.
Remove the parking brake cable the fixing clip(A, B), and then remove the parking brake pedal.

Installation

1.
Install the holding clip (A, B) after fixing the parking brake cable.
2.
Install the parking brake pedal, and then install the parking brake pedal mounting bolts (A) and nut (B).
3.
Adjust the parking brake pedal stroke by turning the adjusting nut (A).
(1)
Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables.
(2)
Adjust the adjusting nut (A) for parking brake pedal stroke 8 ~ 9 notches when operating effort is 294N(30kgf, 66lb).
1.
The parking brake adjustment must be carried out after adjusting the rear shoe.
2.
After adjusting parking brake, notice following matter.
1)
Must be free from clearance between adjusting nut and pin.
2)
Check securely that the brake is not dragging.
4.
Reconnect the parking brake switch connector.
5.
Install the juncting box.
6.
Install the crash pad lower panel.

Adjustment

Parking Brake Pedal Stroke Adjustment
1.
Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables.
2.
Adjust the adjusting nut(A) for parking barke pedal stoke 8 ~ 9 notches when operating effort is 294N(30kgf, 66lbf)

1.
The parking brake adjustment must be carried out after adjusting the rear shoe.
2.
After adjusting parking brake, notice following matter.
1)
Must be free from clearance between adjusting nut and pin.
2)
Check securely that the brake is not dragging.

Parking Brake Lever Assembly. Repair procedures
Removal The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure. 1. Remove the floor console assembly. 2. Disconnect the connector (A) of parking ...

Parking Brake Cable. Repair procedures
Removal Parking brake pedal Type 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the parking brake cable mounting nut (A) and bolts(B). ...

See also:

CVVT (Continuously Variable Valve Timing) System. Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...

Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (C), the bolt (B) and ...

Defroster
CAUTION To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window. ✽ NOTICE If ...