Hyundai Santa Fe: Parking Brake Cable. Repair procedures
Removal
| Parking brake pedal Type |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the crash pad lower panel.
|
| 3. |
Remove the parking brake cable mounting nut (A) and bolts(B).
|
| 4. |
Remove the parking brake cable adjusting nut(A) and the fixing
clip(B), and then remove the parking brake pedal.
|
| 5. |
Remove the floor console.
|
| 6. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 7. |
Raise the vehicle, and make sure it is securely supported.
|
| 8. |
Remove the rear wheel & tire.
|
| 9. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
| 10. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
| 11. |
Installation is reverse of removal.
|
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the floor console.
|
| 3. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 4. |
Raise the vehicle, and make sure it is securely supported.
|
| 5. |
Remove the rear wheel & tire.
|
| 6. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
| 7. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
| 8. |
Installation is reverse of removal.
|
Parking Brake Pedal Assembly. Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the junction box. 4. Disconnect the parking brake switch connector. 5. ...
See also:
Rear Body. Body Repair
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer panel rear corner Tail gate hinge mounting hole (Ø12) Tail gate hinge mounting hole ...
Fuel Pump Motor. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). 4. Release ...
Pressure Sensor. Repair procedures
Inspection If you have trouble code related to the pressure sensor check pressure sensor according to the inspection process. Pressure Sensor Inspection Procedure Measure the resistance of pressure sensor ...
