Hyundai Santa Fe: Radiator Grill. Repair procedures - Front Bumper - Body (Interior and Exterior)Hyundai Santa Fe: Radiator Grill. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
2.
Detach the clips (B), then remove the front bumper energy absorber (A).
3.
Loosen the radiator grill mounting screws.
4.
Unlock the lock pins (B) by pushing it up with a screwdriver or remover and then remove the radiator grill (A).
5.
Install in the reverse order of removal.
•
Replace any damaged clips.

Radiator Grill. Components and Components Location
Component Location 1. Radiator grill ...

Rear Bumper
...

See also:

Components and Components Location
Components 1. Front bumper cover 2. Front bumper side bracket [LH] 3. Front bumper side bracket [RH] ...

Recommended SAE viscosity number
CAUTION Always be sure to clean the area around any filler plug, drain plug, or dipstick before checking or draining any lubricant. This is especially important in dusty or sandy areas and when the vehicle ...

Crankshaft Damper Pulley. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the passenger engine room side cover. 3. Remove the passenger front tire. 4. Remove the crankshaft damper pulley(A). Tightening torque : 166.6 ...