Hyundai Santa Fe: Rear Door Outside Handle. Repair procedures - Rear Door - Body (Interior and Exterior)

Hyundai Santa Fe: Rear Door Outside Handle. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Outside Handle. Repair procedures

Replacement

1.	Remove the hole plug (B).

2.

After loosening the mounting bolt, then remove the rear door outside handle cover (A).

Tightening torque :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.	Remove the rear door outside handle (A) by sliding it rearward.

4.

Install in the reverse order of removal.

•	Make sure the door locks/unlocks and opens/closes properly.

Rear Door Outside Handle. Components and Components Location

Component Location 1. Rear door outside handle ...

Rear Door Latch. Components and Components Location

Component Location 1. Rear door latch ...

See also:

Antenna Coil. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening ...

Under Body. Body Repair
Under Body (2WD) Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual-Measurement Dimensions * These dimensions indicated in this ...

System operation
Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed control to the ...