Hyundai Santa Fe: Rear Oil Seal. Repair procedures - Cylinder Block - Engine Mechanical SystemHyundai Santa Fe: Rear Oil Seal. Repair procedures

Removal

1.
Remove the automatic transaxle.
2.
Remove the drive plate.
3.
Rmove the rear oil sela(A).


Installation

1.
Install rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using SST(09231-H1100, 09214-3K100) (B) and a hammer, tap in the oil seal (A) until its surface is flush with the rear oil seal retainer edge.
2.
Install the drive plate.
3.
Install the automatic transaxle.

Drive Plate. Repair procedures
Removal and Installation 1. Remove the automatic transaxle . 2. Remove the drive plate (A) and the adapter plate (B). Tightening torque : 117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft) • Always ...

Ladder Frame. Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • Mark all wiring and hoses to avoid ...

See also:

Components and Components Location
Component Location 1. DDM (Driver door module) 2. ADM (Assistant door module) 3. Front window motor 4. Rear window motor 5. Rear window switch ...

Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures. If in doubt, we strongly recommend that ...

Welcome system
Headlamp welcome When the headlight(light switch in the headlight or AUTO position) is on and all doors (and tailgate) are locked and closed, the headlight, position light and tail light will come on for ...