Hyundai Santa Fe: Rear Pillar Trim. Repair procedures - Interior Trim - Body (Interior and Exterior)Hyundai Santa Fe: Rear Pillar Trim. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the luggage side trim.
2.
After loosening the mounting bolt, then remove the rear pillar trim (A).
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Rear Pillar Trim. Components and Components Location
Component Location 1. Rear pillar trim ...

Trunk Trim
...

See also:

Crash Pad Under Cover. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Windshield Wiper-Washer Switch. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after loosening 3 screws. 3. Disconnect the connector (A). 4. If necessary of removing ...

Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (C), the bolt (B) and ...