Hyundai Santa Fe (DM): Lumbar support (for driver’s seat)
The lumbar support can be adjusted by pressing the switch.
1. Press the front portion (1) of the switch to increase support, or the rear
portion (2) of the switch, to decrease support.
2. Release the switch once it reaches the desired position.
3. Press the upper portion (3) of the switch to move the support position up, or
press the lower portion (4) of the switch, to move the support position down.
4. Release the switch once it reaches the desired position.
Seatback angle
1. Push the control switch forward or backward to move the seatback to the desired angle. 2. Release the switch once the seat reaches the desired position. Seat height (for driver’s seat) 1. Pull the ...
Headrest
The driver's and front passenger's seats are equipped with a headrest for the occupant's safety and comfort. The headrest not only provides comfort for the driver and front passenger, but ...
See also:
Transfer Fluid. Repair procedures
Inspection • Transfer oil should be inspected and refilled every 60000 km (40000 mile) / 4 year. 1. Remove the under cover (A). 2. Remove the oil filler plug (A). 3. Check the oil level. Oil level must ...
Exterior features
Roof side rails If your vehicle comes with roof side rails, then roof side rails crossbars can be installed on top of your vehicle. The roof side rails crossbars are an accessory and are available at your ...
Transaxle Oil Temperature Sensor. Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
