Hyundai Santa Fe: Roof Antenna. Repair procedures - AVN System - Body Electrical SystemHyundai Santa Fe: Roof Antenna. Repair procedures

Removal

1.
Remove the rear roof trim.
2.
Disconnect the roof antenna connectors (A) from the roof antenna.

3.
Remove the roof antenna (A) after removing a nut.


Installation

1.
Connect the roof antenna connectors.
2.
Install the rear roof trim.
-
Make sure that the cables and connectors are plugged in properly.
-
Check the audio system.

Troubleshooting
Troubleshooting Guide Before Thinking The Product Has Malfunctioned 1. Errors which occur during the operation or installation of the device may be mistaken as a malfunction of the actual device. 2. If ...

See also:

Tail Gate Trim. Repair procedures
Replacement [Tail gate trim] • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent ...

Front Driveshaft. Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...

Heated Schematic Diagrams
System Circuit Diagram Terminal Function Housing Pin Function Wire color Pad A GND Back B HEATER Yellow C NTC+ Back / Yellow D NTC- Back Remote control A GND Back B BAT Red C LED Green D SWITCH White ...