Hyundai Santa Fe: Water Temperature Control Assembly. Repair procedures
Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Loosen the drain plug and drain the engine coolant.
|
| 3. |
Remove the radiator upper hose and lower hose.
|
| 4. |
Disconnect the connectors and then remove the wiring
protector (A).
|
| 5. |
Disconnect the E.T.C cooler hose (A) and the remove
the water temperature control assembly(A).
|
| 6. |
Install in the reverse order of removal.
|
Water Temperature Control Assembly. Components and Components
Location
Components 1. O-ring 2. Water temperature control assembly 3. Water inlet fitting 4. Engine coolant temperature sensor 5. Thermostat 6. Thermostat gasket 7. Oil cooler coolant hose ...
Thermostat. Repair procedures
Removal and Installation Removal of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat. 1. Drain engine ...
See also:
Canister Close Valve (CCV). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. Check that the resistance is within the specification. Specification: ...
Rear Disc Brake. Repair procedures
Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Loosen the hose eyebolt (B) and caliper mounting bolts (C), then remove the rear ...
Immobilizer Indicator Light (Without Smart Key)
This indicator light illuminates: • When the vehicle detects the immobilizer in your key properly while the ignition switch is ON. - At this time, you can start the engine. - The indicator light goes ...
