Hyundai Santa Fe: Windshield Wiper-Washer Switch. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper and lower shrouds
(A) after loosening 3 screws.
|
| 3. |
Disconnect the connector (A).
|
| 4. |
If necessary of removing the wiper & washer switch
(A), release the lock of wiper switch using tool without removing the
steering wheel and the clock spring.
|
| 5. |
Remove the steering wheel.
|
| 6. |
Remove the clock spring.
|
| 7. |
Remove the multifunction switch (A) after loosening
the mounting screws (2EA).
|
Installation
| 1. |
Install the multifunction switch after connecting
the connector.
|
| 2. |
Install the clock spring and steering.
|
| 3. |
Install the upper and lower shroud.
|
| 4. |
Install the steering wheel.
|
Inspection
Wiper Switch
Washer Switch
Components and Components
Location
Component Location 1. Windshield wiper arm & blade 2. Wiper & washer switch (Front) 3. Windshield washer hose 4. Windshield wiper motor & linkage 5. Washer motor 6. Washer reservoir 7. Front ...
Front Wiper Motor. Components
and Components Location
Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Rivet 5. Cowl top cover 6. Bolt 7. Wiper motor & linkage assembly 8. Wiper motor connector ...
See also:
Floor Console Assembly. Repair procedures
Replacement [Console rear complete assembly] [M/T] • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the ...
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure. 1. Insert a slim tool into the slot and gently pry ...
4WD ECU. Repair procedures
Replacement 1. Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool. 2. Disconnect the battery negative cable from the battery 3. Disconnect the 4WD ECU connector (A). ...
