Hyundai Santa Fe: Audio Unit. Repair procedures - Audio - Body Electrical SystemHyundai Santa Fe: Audio Unit. Repair procedures

Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the center air vent duct (A).
3.
Seperate the audio head unit (A) from crash pad after loosening the screws (4EA).
4.
Remove the audio head unit (A) after disconnecting the connectors and cable.

When the compact disc is not ejected, do not remove it forcibly.

Installation

1.
Connect the audio unit connectors and cable.
2.
Install the audio head unit.
3.
Install the center air vent duct.
4.
Connect the negative (-) battery terminal.
A.
Make sure the connector are connected in properly.
B.
Check the audio system.

Audio Unit. Components and Components Location
Components Connector Pin Information No. Connector A Connector B 1 Rear left speaker (+) CAN High 2 Front left speaker (+) TMU Audio (+) (For USA) 3 Front right speaker (+) - 4 Rear right speaker (+) Steering ...

Speakers. Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector is connected ...

See also:

Schematic Diagrams
Circuit Diagram ...

Auto Light Sensor. Repair procedures
Inspection In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's ...

BlueLink Control Switch. Repair procedures
Removal 1. Remove the Electro chromic Inside rear view mirror. Installation 1. Install the Electro chromic Inside rear view mirror. ...