Hyundai Santa Fe: Speakers. Repair procedures - Audio - Body Electrical SystemHyundai Santa Fe: Speakers. Repair procedures

Inspection

1.
Troubleshooting for Speaker
(1)
Basic inspection of speaker
Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector is connected precisely to remove vibration transmitted from body trims and surrounding parts.
(2)
Case Troubleshooting
No.
 Case
 Inspection/Remedy
1
 Trembling sound
1.
Before replacing the speaker, inspect that the mounting screw is installed normally.
2.
After re-installing the speaker, verify that no trembling sound is heard.
3.
When hearing a trembling sound again, replace the speaker with new one.
2
 Noise
1.
Check if the wiring connector is connected normally. If not, reconnect the wiring connector.
2.
In case of radio static, check if there is a noise from CD player.
3.
When a noise is heard on turning radio and CD on, replace the speaker with new one.
In case there is only radio static, this causes from poor radio reception. Thus the speaker needs no repair and replacement.
3
 Poor working
 Inspection of the wiring connection between the battery and the speaker
1.
Before replacing the speaker, inspect the wiring and connections in the speaker circuit.
2.
Check the supplying power to the speaker and the resistance, and then inspect the sound quality.
3.
If the speaker works poorly, replace it with new one.

When handling the speaker :
-
Dropping or rough handling of the speaker can cause damage.
-
Be careful not to spill water or oil on the speaker.
-
Caution when dealing with speaker because the diaphragm is paper and can be easily torn by impact and external force.
-
Electrical mishandling of speakers is not covered by manufacturers warranty.

Removal

Front Speaker
1.
Remove the front door trim.
2.
Remove the front speaker (A) after loosening the screws (4EA).
Rear Speaker
1.
Remove the rear door trim.
2.
Remove the rear speaker (A) after loosening the screws (4EA).
Tweeter Speaker (Front)
1.
Using a screwdriver or remover, remove the front door quadrant inner cover (A).
2.
Disconnect the tweeter speaker connector (A).

Installation

Front Speaker
1.
Install the front speaker.
2.
Install the front door trim.
Rear Speaker
1.
Install the rear speaker.
2.
Install the rear door trim.
Tweeter Speaker (Front)
1.
Connect the connector.
2.
Install the tweeter speaker and front door quadrant inner cover

Audio Unit. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the center air vent duct (A). 3. Seperate the audio head unit (A) from crash pad after loosening the screws (4EA). 4. Remove the audio ...

Antenna. Components and Components Location
Components ...

See also:

Head Lamps. Components and Components Location
Component 1. Head lamp high beam bulb 2. Dust cap (High) 3. Head lamp low beam bulb 4. Dust cap (Low) 5. Turn signal lamp bulb 6. Turn signal lamp socket 7. Side marker bulb 1. Head lamp high beam bulb ...

Special Service Tools
Special Service Tools Item Illustration Application Fuel Pressure Gauge (09353-24100) Measuring the fuel line pressure Fuel Pressure Gauge Adapter (09353-02100) Connection between the high pressure fuel ...

Quarter Garnish. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...