Hyundai Santa Fe (DM): Driveshaft Assembly
Vehicle certification label Repair procedures High Beam Indicator Light
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...
Front Hub / Knuckle / Tone Wheel. Repair procedures
Components 1. Front driveshaft (LH) 2. Inner shaft bearing bracket 3. Front driveshaft (RH) [LH] 1. BJ assembly 2. Clip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ ...
Front Driveshaft. Components and Components LocationSee also:
The vehicle certification label attached on the driver’s side center pillar gives the vehicle identification number (VIN). ...
Inspection [Evap Leak Test] Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV) and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are satisfied. ECM displays ...
This indicator light illuminates: When the headlights are on and in the high beam position When the turn signal lever is pulled into the Flash-to-Pass position. ...
