Hyundai Santa Fe: Door Scuff Trim. Repair procedures - Interior Trim - Body (Interior and Exterior)Hyundai Santa Fe: Door Scuff Trim. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the front door scuff tirm (A).
[Front]
2.
Using a screwdriver or remover, remove the rear door scuff tirm (A).
[Rear]
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Door Scuff Trim. Components and Components Location
Component Location 1. Front door scuff trim 2. Rear door scuff trim ...

Cowl Side Trim. Components and Components Location
Component Location 1. Cowl side trim ...

See also:

Troubleshooting
Troubleshooting Ignition System Symptom Suspect Area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch Inspect ignition lock switch, or replace as required Ignition coil ...

Headlamp bulb
WARNING - Halogen bulbs Halogen bulbs contain pressurized gas that will produce flying pieces of glass if broken. Always handle them carefully, and avoid scratches and abrasions. If the bulbs are lit, ...

Components and Components Location
Components Location 1. PCV Valve 2. Canister 3. Purge Control Solenoid Valve (PCSV) 4. Fuel Tank Pressure Sensor (FTPS) 5. Canister Close Valve (CCV) 6. Fuel Level Sender (FLS) 7. Fuel Tank Air Filter ...