Hyundai Santa Fe: Trailing Arm. Repair procedures - Rear Suspension System - Suspension SystemHyundai Santa Fe: Trailing Arm. Repair procedures

Removal

1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Remove the parking brake cable.
3.
Loosen the nuts & bolts and then remove the trailing arm (A) with the rear axle.
Tightening torque
Trailing arm :
44.1 ~ 53.9N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)
Parking brake cable bracket :
6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0lb-ft)

4.
Loosen the mounting bolt and then remove the trailing arm (A) with the frame.
Tightening torque:
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

5.
Installation is the reverse of removal.
6.
Check the rear alignment.

Rear Coil Spring. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

Rear Assist Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

See also:

Door Mood Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. 3. Disconnect the door mood lamp connectors (A). 4. Remove the door mood lamp (A) after loosening the screws (3EA). ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS). Schematic Diagrams
Circuit Diagram ...