Hyundai Santa Fe (DM): Front Seat Belt Buckle. Repair procedures - Front Seat Belt - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Seat Belt Buckle. Repair procedures

Replacement

1.
Remove the front seat assembly.
2.
Disconnect the front seat belt buckle connector wiring (A).
3.
After loosening the mounting nut, then remove the front seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Front Seat Belt Buckle. Components and Components Location
Component Location 1. Front seat belt buckle ...

Rear Seat Belt
...

See also:

Description and operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check. The ...

Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a malfunction ...

Curtain Airbag (CAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim. 3. Disconnect the curtain airbag harness connector (A). 4. After loosening ...