Hyundai Santa Fe: Fuel Tank Pressure Sensor (FTPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Santa Fe: Fuel Tank Pressure Sensor (FTPS). Repair procedures

Inspection

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the rear seat.
(Refer to Body - "Rear Seat Assembly")
3.
Remove the fuel pump service cover (A) in the trunk.
4.
Disconnect the fuel tank pressure sensor connector (A), and then remove the fuel tank pressure sensor.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Install in the reverse order of removal.

Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams
Circuit Diagram ...

Injector. Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is controlled by ...

See also:

Vehicle handling instructions
As with other vehicles of this type, failure to operate this vehicle correctly may result in loss of control, an accident or vehicle rollover. Specific design characteristics (higher ground clearance, ...

Relay Box (Engine Compartment). Components and Components Location
Component Location ...

ESC OFF Switch. Description and Operation
Description 1. The ESC OFF switch is for the user to turn off the ESC system. 2. The ESC OFF lamp is on when ESC OFF switch is engaged. ...