Hyundai Santa Fe: Heated Repair procedures - Steering wheel - Steering SystemHyundai Santa Fe: Heated Repair procedures

Inpection

1.
Measure a resistance of NTC and Heated pad.
A.
NTC resistance(Black / Yellow, Black) - 10.0 kΩ ± 10% (25°C)
B.
Heated pad resistance (Yellow, Black) - 1.6 ~ 2.0 Ω ± 10%
2.
Measure a temperature.
A.
The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute
B.
The temperature of wheel surface grip must keep 38°C ± 4°C after 25 minute
C.
At that time switch on, all measure point (1~8)


Heated Schematic Diagrams
System Circuit Diagram Terminal Function Housing Pin Function Wire color Pad A GND Back B HEATER Yellow C NTC+ Back / Yellow D NTC- Back Remote control A GND Back B BAT Red C LED Green D SWITCH White ...

Flex Steer. Components and Components Location
Components Location 1. Flex steer switch ...

See also:

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is ...

Power Window Motor. Repair procedures
Inspection Front Power Window Motor 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. 3. Disconnect the connector (A) from the motor. (A : Safety, B : Standard) 4. Connect ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. ...