Hyundai Santa Fe (DM): Horn
Rear Door Belt Inside Weatherstrip. Repair procedures Ignition switch position Rail Pressure Sensor (RPS). Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. 3. Remove the steering column upper and lower shrouds (A) after removing 3 screws. 4. Disconnect the light switch ...
Repair procedures
Component Location 1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn (Low pitch/Disk type) 3*. Horn (Low pitch/Shell type) 4. Horn (High pitch/Disk type) 4*. Horn (High pitch/Shell type) 5. ...
Components and Components LocationSee also:
Replacement 1. Remove the rear door trim. 2. Remove the rear door belt inside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips. ...
LOCK The steering wheel locks to protect against theft. The ignition key can be removed only in the LOCK position. When turning the ignition switch to the LOCK position, push the key inward at the ACC ...
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Condition Output Voltage (V) Idle Approx. 1.2 1,500 rpm ...
