Hyundai Santa Fe: Repair procedures - Horn - Body Electrical SystemHyundai Santa Fe: Repair procedures

Removal

1.
Remove the front bumper cover.
2.
Remove the bolts and disconnect the horn connectors, then remove the high pitch horn (A) and low pitch horn (B).
[Disk type]

[Shell type]

Installation

1.
Install the horns after connecting the horn connectors.
2.
Install the front bumper cover.

Inspection

Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.
Horn Relay Inspection
1.
Remove the horn relay (A) from the engine room relay box.
2.
There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
3.
There should be no continuity between the No.30 and No.87 terminals when power is disconnected.

Components and Components Location
Component Location 1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn (Low pitch/Disk type) 3*. Horn (Low pitch/Shell type) 4. Horn (High pitch/Disk type) 4*. Horn (High pitch/Shell type) 5. ...

AVN System
...

See also:

Light bulbs
WARNING - Working on the lights Prior to working on the light, firmly apply the parking brake, ensure that the ignition switch is turned to the “LOCK”position and turn off the lights to avoid sudden ...

Direct Electro Hydraulic Actuator Coupling. Components and Components Location
Component Location 1. Coupling assembly 2. Propeller shaft 3. Transfer assembly Components 1. Coupling assembly 2. Input shaft 3. Pressure sensor 4. Extension wiring 5. Oil hydraulic Motor(Actuator) ...

ALL Wheel Drive (AWD) transfer mode selection
✽ NOTICE When driving on normal roads, deactivate the AWD LOCK mode by pushing the AWD LOCK button (the indicator light goes off). Driving on normal roads with AWD LOCK mode(especially, when cornering) ...