Hyundai Santa Fe: Ignition Coil. Repair procedures - Ignition System - Engine Electrical SystemHyundai Santa Fe: Ignition Coil. Repair procedures

Removal

1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connector (A).

•
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

4.
Remove the ignition coil (A).

Installation

1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)

Inspection

1.
Measure the primary coil resistance between terminals (+) and (-).

Standard value: 0.62Ω ± 10%

Ignition Coil. Schematic Diagrams
Circuit Diagram ...

Spark Plug. Description and Operation
Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture therein by means ...

See also:

Warning Messages
Shift to "P" position (for smart key system and automatic transaxle) This warning message illuminates if you try to turn off the engine without the shift lever in P (Park) position. At this time, ...

Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be used to identify ...

Fuel Pump Motor. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). 4. Release ...