Hyundai Santa Fe: Line Pressure Control Solenoid Valve. Schematic Diagrams - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe: Line Pressure Control Solenoid Valve. Schematic Diagrams

Circuit Diagram


Line Pressure Control Solenoid Valve. Specifications
Specifications Direct control VFS[LINE Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14~9.81 (5.1~0.1,72.54~1.42) Current value(mA) 50~850 Internal resistance(Ω) ...

Line Pressure Control Solenoid Valve. Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

See also:

Rear Stabilizer Bar. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

Noise and smoke
When the air bags inflate, they make a loud noise and they leave smoke and powder in the air inside of the vehicle. This is normal and is a result of the ignition of the air bag inflator. After the air ...

Cylinder Head Cover. Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Remove the engine cover. 3. Remove the air duct and air cleaner assembly. 4. Disconnect the exhaust OCV (Oil control valve) connector (A). 5. Disconnect ...