Hyundai Santa Fe: Parking Assist Sensor. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bumper cover.
|
| 3. |
Disconnect the connector (B) from the parking assist
sensor (A).
|
| 4. |
Pull out the sensor (A) by opening the sensor holder
(B) out.
|
Installation
| 1. |
Install the rear ultra sensor after connecting the
connector.
|
| 2. |
Install the rear bumper cover.
|
| 3. |
Connect the negative (-) battery terminal.
|
See also:
SS-A Solenoid Valve(ON/OFF). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
In the event of brake failure
If service brakes fail to operate while the vehicle is in motion, you can make an emergency stop with the parking brake. The stopping distance, however, will be much greater than normal. WARNING - Parking ...
Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
