Hyundai Santa Fe: Rear Bumper beam Assembly. Repair procedures - Rear Bumper - Body (Interior and Exterior)Hyundai Santa Fe: Rear Bumper beam Assembly. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear bumper cover.
2.
Disconnect the rear bumper beam mounting wiring harness (A).
3.
After loosening the mounting screws and clips, then remove the rear bumper beam assembly (B).
4.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Rear Bumper beam Assembly. Components and Components Location
Component Location 1. Rear bumper beam assembly ...

Front Seat
...

See also:

SRS Care
The SRS is virtually maintenancefree and so there are no parts you can safely service by yourself. If the SRS air bag warning light "" does not illuminate, when you turn the ignition on, or continuously ...

Jump starting procedure
✽ NOTICE If the battery is discharged, the engine can be started using a battery of another vehicle and two jumper cables. Only use jumper cables with fully insulated clamp handles. To prevent personal ...

Temperature control
The temperature control switch allows you to control the temperature of the airflow in the vehicle. To change the temperature: Press the (red) switch to increase temperature. Press the (blue) switch to ...